Valspar Composites
 
Mold Making and Repair
 


Mold Making

  1. Introduction
  2. Building a Plug
  3. Procedure for Multiple Section Plugs
  4. Preparation for Resurfacing
  5. High Build Polyester Primers
  6. High Build Polyester Topcoat
  7. Helpful Hints and Important Reminders
  8. Catalyst Chart
  9. Plug Building with Other Materials
  10. Preparing the Plug for a Mold
  11. Building a Fiberglass Mold
  12. Organizing the Gel Coat Booth
  13. Gel Coat Applications
  14. Mold Lamination
  15. Removing the Mold from the Plug
  16. Building the Glass Master
  17. Mold Birth Certificate
   
 

Mold Repair

 Printable .pdf Version of Entire Document
  1. Using Putty or Patching Paste
  2. Repairing Punctures
  3. Re-Spraying the Gel Coat
  4. Sanding

Valspar
Mold Release Products

 
Disclaimer
The information and recommendations found in this web site
are intended for FRP Professionals. Results of repair or maintenance are dependent on
many variables. No warranties of any kind are expressed or implied.