| |
|
Printable
Version (.pdf)
|
|
87X150
Plastilease Fast Dry II Mold Release
Product
Description
87-X150
Plastilease is a highly reactive, semi-permanent, mold release
that bonds to fiberglass reinforced plastic molds for a durable
release surface. Gel coats and polyester resins are released with
a minimum of contamination providing clean, ready-to-use parts.
87-X150
forms a thin film which is especially advantageous for use on patterned
surfaces such as non-skid areas where it won't clog the design.
Typical
Physical Characteristics (All Tests at 77º
F.)
| Weight
Per Gallon: |
6.1 - 6.5 Pounds
|
| Flash
Point: |
10°
F.; Seta-Flash Closed Cup
|
| Shelf
Life: |
One
year from date of shipment.
|
| VOC
Per EPA Method 24: |
6.75
lb/gallon or 743 gm/liter |
Application
87-X150
Plastilease may be applied by brushing or wiping on clean molds.
Care should be taken to wash off with acetone or toluene any traces
of mold release wax. Traces of mold wax will interfere with bonding
of 87-X150 to the mold surface. The mold release should be applied
to clean mold surfaces and gently buffed dry. Five to ten minutes
should be allowed for reaction depending on ambient relative humidity.
Use six or seven coats with time for reaction after each application.
A fresh treatment of 87-X150 can be applied without removing the
remains of previous coatings of 87-X150. It is important to make
sure the mold is completely treated (no missed areas) to avoid mold
sticking. The container should be kept closed as much as possible
to prevent premature reaction with water vapor in the air.
|
LIMITED WARRANTY
AND DISCLAIMER
The
data on this sheet represent typical values. Since application variables are
a major factor in product performance, this information should serve only as
a general guide. Valspar assumes no obligation or liability for use of this
information. UNLESS VALSPAR AGREES OTHERWISE IN WRITING, VALSPAR MAKES NO WARRANTIES,
EXPRESS OR IMPLIED, AND DISCLAIMS ALL IMPLIED WARRANTIES INCLUDING WARRANTIES
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR USE OR FREEDOM FROM PATENT INFRINGEMENT.
VALSPAR WILL NOT BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
Your only remedy for any defect in this product is the replacement of the defective
product, or a refund of its purchase price, at our option.
|
|
|
