| |
Product
Description
5794C Series Envirotech Fast Cure Clear Marble Gel Coats are
specifically formulated for use in cultured marble manufacturing
and in processes in which excellent clarity is required. They cure
to an extremely tough, classic clear finish that resists staining
and abrasion, meets ANSI Z124 standards and helps meet your emissions
needs.
5794C
Series Gel Coats are designed to work over challenging mold releases
and provide tack-free surfaces.
Typical
Physical Characteristics (All Tests at 77º
F.)
| Weight
Per Gallon: |
8.8 - 9.2 pounds
|
|
Viscosity:
|
2200
- 2200 cps. Brookfield LVT #4 @ 60 rpm
|
| Thix
Index: |
5 .0 - 7.0
|
| Gel
Time: |
9 - 12 Minutes; 2% MEKP @ 77° F
|
| Cure
Time: |
60 Minutes
|
| Flash
Point: |
88º
Fahrenheit |
| Shelf
Life: |
3 months from date of shipment
|
| %
Monomer: |
41
+/- 1% (Note: Envirotech Clear MarbleGel Coats
can be customized as low as 38%)
|
|
Values
listed are typical indicators only. In-mold coating physical
properties
may vary with usage and storage conditions.
|
Application
WORKS
EXTREMELY WELL IN CONVENTIONAL EQUIPMENT
5794C
Series Envirotech Clear Marble Gel Coats are formulated
for spray application as supplied. Thinning is not recommended.
For catalyzation, use MEKP @ 2% for gel times of 9 - 12 minutes
at 77° F. Do not catalyze at levels below 1-1/4% or above 3%.
Apply in several thin overlapping coats rather than a single thick
coat to help avoid sagging, porosity, solvent entrapment and other
defects. Make sure the air pressure is adjusted properly and that
the spray gun lines are free of solvent, water and oil. Apply to
a thickness of 16 - 20 mils wet. Brush application is not recommended.
- Store
containers indoors or under cover.
- Normal
storage area temperature should be 65° F. - 80° F.
- Use
only original containers full and sealed.
- Keep
containers away from heating pipes or radiators.
- Use
a "first-in-first-out" system of stock rotation to ensure
use within 90-day period.
|
LIMITED WARRANTY
AND DISCLAIMER
The
data on this sheet represent typical values. Since application variables are
a major factor in product performance, this information should serve only as
a general guide. Valspar assumes no obligation or liability for use of this
information. UNLESS VALSPAR AGREES OTHERWISE IN WRITING, VALSPAR MAKES NO WARRANTIES,
EXPRESS OR IMPLIED, AND DISCLAIMS ALL IMPLIED WARRANTIES INCLUDING WARRANTIES
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR USE OR FREEDOM FROM PATENT INFRINGEMENT.
VALSPAR WILL NOT BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
Your only remedy for any defect in this product is the replacement of the defective
product, or a refund of its purchase price, at our option.
|
|
|
