| |
Product
Description
5794W90069 Envirotech Bilge Gel Coat is truly a Low Styrene
and Low HAP Gel Coat. Envirotech gel coats are made to meet or exceed
the emission standard for your manufacturing process. Ease of application,
high heat distortion temperatures and low HAP content make Envirotech
one of the premier gel coat choices in today's marketplace. For
your FRP parts, Envirotech provides maximum protection with minimal
emissions.
Typical
Physical Characteristics (All Tests at 77º
F.)
| Weight
Per Gallon: |
10.5-11.5 Pounds
|
|
Viscosity:
|
17,000-21,000 cps.Brookfield
LVF #4 @ 6 rpm
|
| Thix
Index: |
5.0 - 8.0
|
| Gel
Time: |
7 - 10 Minutes 1.8%
MEKP
|
| Cure
Time: |
45 Minutes
|
| Shelf
Life: |
2 months from date of shipment
|
| %
HAPs: |
22
- 23% |
|
Values
listed are typical indicators only. In-mold coating physical
properties may vary with usage and storage conditions.
|
Application
5794W90069
Envirotech Bilge Gel Coat is formulated for Spray application
as supplied. Thinning is not generally recommended. This product
contains styrene suppressant(s). For
Catalization use MEKP @ 1.8% for gel time of 7 – 10 minutes
at 77º
F. Do not catalyze at levels below 1% or above 3% as this may cause
gel coat defects. Apply
in several thin overlapping coats rather than a single thick coat.
This will help avoid sagging, porosity, solvent entrapment and other
defects. Make sure the air pressure is adjusted properly, and that
the spray gun and lines are free of solvent, water, and oil. Apply
to a thickness of 18-22 mils wet in a minimum of four passes. Brush
application is not recommended.
•
Store containers indoors or under cover.
• Normal storage area temperature should be 65º F.
- 80º F.
• Use only original containers full and sealed.
• Keep containers away from heating pipes or radiators.
• Use a "first-in-first-out" system of stock rotation
to ensure use within 90 day period.
|
LIMITED WARRANTY
AND DISCLAIMER
The
data on this sheet represent typical values. Since application variables are
a major factor in product performance, this information should serve only as
a general guide. Valspar assumes no obligation or liability for use of this
information. UNLESS VALSPAR AGREES OTHERWISE IN WRITING, VALSPAR MAKES NO WARRANTIES,
EXPRESS OR IMPLIED, AND DISCLAIMS ALL IMPLIED WARRANTIES INCLUDING WARRANTIES
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR USE OR FREEDOM FROM PATENT INFRINGEMENT.
VALSPAR WILL NOT BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
Your only remedy for any defect in this product is the replacement of the defective
product, or a refund of its purchase price, at our option.
|
|
|
